Recent content by Nightshifter

Hello Bolden! I could never use launch control would always cut around 4000 - 4500 rpms so I had to drone off the line which cost me time :/ No physical mods... just the jb4. Map E20 - 30 (varied) never went below 5.2 on the Draggy. I guess kia beefed up the nannie on the 2022's =) Same with the...

Last call to buy for $350. I talked to Terry and it doesn't matter who the owner is to get updated clips.

No bluetooth... just the Unit w/ OBDII Cable. Buy it new for 529.00 with or without Tax depending on your situation.

JB4 Unit for 2.5L Turbo V2 Harness. Great condition! Used for a few months on leased Stinger to check it out. Worked really well on all 3 Map Modes. $350

**UPDATE Problem resolved ( so far...lol). Okay... so it wasn't the fuel pump issue (i didn't think so because it only happens when using launch control). Wasn't any spark plug issues or ECU problems... I consulted Burger on the issue, and Terry said that it definitely sounds like 'throttle...

Oh stock it doesn't happen... forgot you're not using JB4 yet :) between ~4k - 5k .. but the logs look fine (according to burger tuning) It's either the JB4 extra boost is tripping some sorta safety or the Fuel Pump can't handle it...? But then again... it only happens if I use launch...

AWD drive here too! Did you use launch control doing a 0 - 60? If so... did you get fuel cut (feeling) @ 4k - 5k rpms... dropping down sum then shifting to 2nd?

Do you have RWD or AWD? I really think the 2.5T is a major improvement and the handling is so much better overall. Doesn't feel like a waterbed ;)

None so far... awaiting updates myself... Still don't know why I can't use launch control and have to resort to brake boosting off the line (for AWD ain't no thang...) Also the adapters would be nice... right now i have some electrical tape around them to hold in place :P When I'm running Map 3...

https://mechanicbase.com/engine/limp-mode/ "...The limp mode often reduces the power and limits the engine’s RPM to drive your car to a workshop without damaging the engine. For example, if the engine control unit detects that your turbo boost pressure is 2.0 bar when the maximum boost pressure...

Okay... 5.26 seconds 5 - 60 Map 3 :) Getting there! Sometimes I'm getting a fuel cutoff or limp mode around 5000 rpm 1st - 2nd using launch mode with Map 3. Hmmm... so i had to do 5 - 60 instead. Anyone know why this is happening only using launch mode let me know! Fuel cutoff, blowout, limp...

Okay... installed the JB4 (beta) and this is result with Map 1 (+2.5 psi) so far... during the day... down to 5.43 sec (1 ft. rollout) so far... I filled up with E20-E25ish and going to test Map 3 next ... need to connect the CANbus! :p

I avg. 33 mpg on the expressway (i-15 SoCals... ups & downs).

Could be :) Ordered a JB4 for this car... going to run Map 4 E20 and see how much quickness is gained :P on the G80 2.5L Graph (burger site) it was ~ 70 WHP increase... (254ish to 322ish).

Best time so far was 5.66! Seems you can't do an EBRake launch with the 2022... I was able with my previous stingers... but not the 2022.. it won't build boost.. just falls flat after releasing EBRake or hangs :/